What Should We Pay Attention To When Using Electric Hydraulic Press For Laboratory?
YLJ-30TAS electric hydraulic press with digital display is a small powder forming equipment commonly used in laboratories, suitable for scientific research on ceramics, powder metallurgy, batteries, cement and other materials. In order to ensure the safe operation and extend the service life of electric hydraulic press for laboratory, users need to pay special attention to the following points during operation:
Read the manual:
Before use, please read the product manual carefully to fully understand the use and operation specifications of the equipment to prevent safety hazards caused by improper operation.
Check the power grounding:
To ensure personal safety, check whether the power supply of the electric hydraulic press with pressure controller is reliably grounded before operation to avoid electric shock accidents.
Loosen the oil filling hole screw:
Before starting the machine, you need to loosen the oil filling hole screw so that the electric hydraulic press with pressure controller can operate normally during the pressurization process.
Monitor the upper limit of pressure:
The upper limit of the pressure gauge of the laboratory hydraulic press machine with programmable controller is 35MPa. Exceeding this range may cause equipment damage or even danger. Operators need to monitor the pressure gauge at all times to avoid over-limit operation.
Pay attention to the piston stroke limit:
The upper limit of the piston lift is 20mm. Exceeding this stroke may affect the automatic reset function of the piston and affect the normal operation of the laboratory hydraulic press machine with programmable controller.
Ensure that the lubricating oil and hydraulic oil are sufficient and clean:
Before operating the electric hydraulic press for laboratory, check whether the lubricating oil in the gearbox is sufficient and ensure that the hydraulic oil is clean. It is recommended to use 30# engine oil.
The above points are important precautions that must be followed when operating electric hydraulic press for laboratory. Strictly following the instructions can not only improve work efficiency, but also effectively extend the life of the equipment and ensure safe operation.
I hope the above content can help you when using electric hydraulic press with pressure controller. We are very aware of the importance of equipment in scientific research, so we are always committed to providing customers with high-quality products and professional technical support. Whether in the purchase, installation or post-maintenance of the equipment, our team will provide you with a full range of service guarantees with rich experience and a high sense of responsibility.