How to choose Diamond Wire Saw With Protective Chambe Equipment According To Application
Choose Diamond Wire Saw With Protective Chambe according to the accuracy;
Rough cutting equipment: SYJ-D2000, SYJ-40, SYJ-50, SYJ-200H Cutting accuracy unit is in the millimeter level Precision cutting equipment: SYJ-D4000, SYJ-150, SYJ-160, SYJ-200 Cutting accuracy is about ±0.05mm High-precision cutting equipment: STX full series diamond wire cutting machine and diamond curve cutting machine, SYJ-400, SYJ-800, SYJ-1610, SYJ-1802 Cutting accuracy depends on the equipment, the minimum cutting accuracy is ±1um.
Choose Diamond Wire Saw With Protective Chambeaccording to the turning angle:
Graduated angle table: STX-201, STX-202A, STX-604, SYJ-150, SYJ-160, SYJ-400 360° turntable with scales and vernier caliper reading, but the angle error will be caused by the viewing angle of the eyes. The error varies from person to person, and the actual measurement is ≤20′. Among them, STX-201, STX-202A (Q/B) and SYJ-400 are equipped with standard 90° fixtures. If you only cut a 90° angle, you can choose to configure it.
Automatic precise turning angle: STX-604A, STX-1203 (A), STX-2401, SYJ-800. The program controls the precise turning angle, and the display accuracy is 0.01° (0.6′). Directional cutting requires turning and tilting: 360° turning and 15° tilting.
Manual angle adjustment: STX-202A (Q/B), STX-604, (STX-402).
Automatic angle adjustment: STX-203, STX-605A (B).
Select Diamond Wire Saw With Protective Chambe according to other conditions
For precise grooving, it is recommended to use an external cylindrical cutting machine, i.e. SYJ-400, SYJ-800, SYJ-1610, SYJ-1802. For cutting cubic particles below 1mm, it is recommended to use SYJ-1610 and SYJ-1802. It is recommended to choose a diamond wire saw (STX series) in the following situations.
1. Cutting thin slices of samples such as cubes, cuboids, cylinders, etc. with high height.
2. Cutting of fragile samples, crystals, shale, etc.
3. Crystal orientation.
4. Organization modeling.
5. Preparation of test samples, transmission samples, tensile samples, etc.
6. Cutting of samples that cannot be added with coolant (water, emulsion, oil, etc.).